Used NetApp FAS Series Storage Array

Block 1:

How Much Does Used NetApp FAS Series Storage Array Cost in 2026?

Used units (field-tested, <5 years old) range from $4,200 to $18,500 in 2026, depending on drive count (4–15 bay configurations) and throughput specs. Refurbished models with 3-year warranties start at $6,800–$24,000, offering 40–65% savings vs new FAS8300 equivalents ($16,000–$30,000 MSRP). Caveat: Arrays with >10% drive rebuild rates in SMART diagnostics (common in 2018–2020 deployments) may add $1,200–$3,500 for controller replacement. Always verify IOPS performance against the original spec sheet—units below 1.1GB/s sustained throughput are likely candidates for capacitor replacement.

Block 2:

NetApp FAS Series Specifications and Compatible Tools

Key specs: 1.2GB/s max throughput, 1ms latency, 4–10 drive bays (SAS/SATA/NVMe), 90–240V DC input, 40–60°C operating temp. Compatible with:

• Applied Materials Centura 5500 (2015–2018) via Fibre Channel HBA
• Lam Research Endura Etch (2017–2021) using 10GbE iSCSI
• KLA-Tencor SpectraMax (2016–2020) with SAS expander modules
  Warning: Do not install in ASML NXT:1700 systems (2022+) without firmware upgrade to NetApp ONTAP 9.9P3—older versions cause LUN mapping errors (error code 1203).

Block 3:

What to Check Before Buying a Used NetApp FAS Series Storage Array in 2026

1. Drive health: Use sysstat to confirm <5% disk latency variance; reject units with >15% rebuild rate.
2. Power supply: Measure output with a multimeter—voltage must stay within ±3% of 12V/5V rails under full load.
3. Firmware alignment: Verify ONTAP version matches tool requirements; arrays older than 2019 need $800+ license fees for NVMe support.
4. Network throughput: Stress-test 10GbE ports with Iperf3; sustained <9.5Gbps indicates faulty SFP+ transceivers