Photoresist Coater — Used CEE Apogee 200 Benchtop Spin Coater (Bidservice)

How Much Does Used CEE Apogee 200 Benchtop Spin Coater Cost in 2026?

The used CEE Apogee 200 benchtop spin coater typically lists at a fixed price of $6,950 in 2026, reflecting its condition grade B and average age of 10–15 years. Refurbished units from vendors like Ferrotec or Axus Technology may add $500–$1,000 for motor and bearing replacements but reduce downtime risk by 70%. Compared to new models (priced at $11,583–$17,375), buyers save 40–60%, though this assumes no hidden repair costs. A failed purchase—such as a unit with a degraded vacuum system—can cost $5,000 in lost production and repair labor. Note: The fixed price range excludes older units (pre-2010) with higher wear, which may require 20–30% additional budget for parts.

Used CEE Apogee 200 Benchtop Spin Coater Specifications and Compatible Tools

The CEE Apogee 200 operates at 100–6,000 RPM with spin times up to 999 seconds, typically achieving ±1% speed accuracy. It supports wafer sizes up to 8 inches and has a vacuum chuck with 20–30 mTorr hold capacity. Lifespan metrics suggest 50,000–70,000 coating cycles before motor degradation. Compatible tools include older Applied Materials 1200 Series (2005–2010) and Lam Research P1000 systems. However, avoid pairing with AMAT 45-1234-5 nozzles, which lack the 0.5 mm alignment tolerance required for even coating. A failed coating due to misalignment can waste $3,000 in photoresist and 12 wafers. Verify specs with the seller, as pre-2008 models may lack the dual-speed motor found in later variants.

What to Check Before Buying a Used CEE Apogee 200 Benchtop Spin Coater in 2026

1. Production Year: Reject units older than 2010 due to brittle vacuum seals (replacement cost: $800).
2. Motor and Bearing Wear: Run a 10-minute spin at 5,000 RPM; vibration exceeding 0.05 mm amplitude indicates bearing failure.
3. Vacuum System Test: Use a digital manometer to confirm <10 mTorr pull-down in 30 seconds; failure here risks $2,500 in wafer adhesion issues.
4. Software Version: Units with firmware pre-2015 lack the auto-calibration feature, increasing setup time by 40%.
   A bad purchase—such as one with a seized motor—can halt production for 3–5 days, costing $5,000 in downtime. Always request a spin consistency test (RPM variation >5% over 10 cycles is a hard reject).

FAQ

Q: How does the used price compare to a new CEE Apogee 200?
A: Used units save 40–60% versus new prices of $11,583–$17,375. New